Cabinet Installation in Morristown.

Cabinet installation set to the floor

A cabinet run is only as straight as the day it gets set. On the drawing every base is 34-1/2 inches and every wall is plumb; in a real Morristown house neither holds. Dunn Trim Co. sets cabinetry as the install sub across the Lakeway Area — kitchens, vanities, islands, and pantries set flat and ready for counters. We install the pre-built boxes your builder, cabinet shop, or homeowner supplies. We don't design the layout and we don't sell the cabinets; we make what's specified hang true. Most of our Morristown cabinet work comes through general contractors and custom builders who want the package run as one line on the schedule.

Set off the floor's high point, scribed to the wall

Setting a run right starts at the floor. We shoot the whole run for its high point and set every cabinet off that line, shimming down to it so the countertop templates flat and the toe-kick reads level. Uppers hang to a snapped level line, so a long wall carries its crown straight end to end. Fillers and finished end panels get scribed to the wall, because the walls in a real house are never quite square, and a filler cut straight leaves a gap a client finds with one look down the cabinet line. From there we fasten into the studs, not just the drywall, and draw the boxes tight and coplanar so the face frames form one flat plane for the counter fabricator. Last comes the six-way hinge and slide adjustment down the whole run: every door reveal even, every drawer face aligned, every gap consistent top to bottom.

Builder-, homeowner-, or shop-supplied boxes

We set whatever shows up on site, as long as it's a pre-built box: a builder's package, a homeowner's delivery, or a local cabinet shop's custom work we're installing on their behalf. We don't assemble flat-pack; we install finished cabinets. Homeowner-supplied orders get checked against the packing list the day they land, so a missing filler or the wrong panel doesn't stall install day, which is the thinking we lay out in our field note on installing homeowner-supplied cabinets. We install and we don't design, so a homeowner who needs the kitchen laid out first gets routed to a design partner, and the install stays with us. Cabinet shops and interior designers working the Morristown market keep their layout and their relationship; we set their drawings plumb, level, and tight to the wall.

Built for the Morristown market, quoted per kitchen

Morristown's cabinet work runs the full range: full custom kitchens in the Cherokee Lake homes, updated kitchens and vanity swaps in the established in-town neighborhoods getting renovated, and clean, repeatable sets in the move-up subdivisions filling the edges of town. Older in-town homes have settled, and a settled house hands you racked openings and floors that fall off toward an exterior wall — those are the conditions scribing and adjustment are for. We coordinate the set day with your countertop fabricator so template happens on time and the punch list doesn't fill up with misaligned doors. One honest note: Morristown is about an hour northeast of our Knoxville base up I-40 and US-11E, a longer haul than our in-county work, so we plan the drive into the schedule and put it on the bid straight. Cabinet setting is quoted per kitchen after we walk it, since box count, scribe conditions, and site access all move the number. See the rest of what we run across the Lakeway market on our Morristown service area page, or the full cabinet installation service.